#Sainsmart arduino uno pinout pdf pdf

I have already figured out the font issue with the supplied lib, and it is compiling and loading fine.Р”Р„lso was wondering is there any of the pins that go to the I2C that IРІР‚в„ўve stuck in the wrong place? IРІР‚в„ўm going o try to attach the example, not sure if it will let me. LED-A, VCC, GND 3.3V, 5V, GND (Power) - PowerР”В_CLK 6 (PWM -also digital) - Touch controllerР”В_CS 5 (PWM -also digital) - Touch controllerР”В_IN 4 (PWM -also digital) - Touch controllerР”В_OUT 3 (PWM -also digital) - Touch controllerР”В_IRQ 2 (PWM -also digital) - Touch controllerР”Р„nd the sketch IРІР‚в„ўm using is the Utouch calibration hat I was directed to use, I would post but its telling me it has a length error. RS, WR, CS, RST 38, 39, 40, 41 (Digital) - Screen control signals

#Sainsmart arduino uno pinout pdf pdf

Using the pinout pdf and the calibration and example libraries I think ive got the wiring almost figured out, except when I load a library I get a blank white screen.Р”ВB0-DB7,DB8-DB15 D37-D30,D22-D29 - 16-bit data for screen So a while back I decided to get back into the microcontrollers and was at the store and they had a sainsmart 4.3' tft lcd, I have a mega 2560 IРІР‚в„ўm wiring it to, it has the 40 pin connector, I know they have a shield it snaps into and then pops directly on the mega but for the internal layout of the case its going into I need the flexability of wires.